Posted by Ian [ 68.183.19.66 ] on February 19, 2007 at 01:11:33:

In Reply to: Compresison ratio and front chamber size posted by Wayne Parham on February 14, 2007 at 13:38:47:

I've modeled a few throatless horns in hornresp before and I always wondered whether the modeling was accurate for that case?

Some drivers looked very good on throatless horns in hornresp, so I'd consider making one if I thought hornresp was relatively accurate.

I think this is a good question though. I've heard a lot of discussion about waveguides lately, but not much about cone, particularly midrange, waveguides.

Replies:

• Re: Compresison ratio and front chamber size - Wayne Parham 10:53:28 02/19/07 (9)
  • Re: Compresison ratio and front chamber size - Cuppa Joe 23:38:22 02/21/07 (8)
    • Re: I was considering a B&C 8PE21 - swett 21:37:28 02/22/07 (3)
      • Re: I was considering a B&C 8PE21 - Cuppa Joe 23:03:32 02/22/07 (2)
        • Re: I was considering a B&C 8PE21 - Wayne Parham 01:15:09 03/01/07 (1)
          • Re: I was considering a B&C 8PE21 - Cuppa Joe 21:14:58 03/01/07 (0)
    • Re: Compresison ratio and front chamber size - Wayne Parham 11:28:26 02/22/07 (3)
      • Re: Compresison ratio and front chamber size - Cuppa Joe 22:50:52 02/22/07 (2)
        • Straight side walls - Wayne Parham 12:12:36 02/23/07 (1)
          • Re: Straight side walls - Cuppa Joe 22:08:03 02/23/07 (0)