Posted by bill epstein [ 65.189.211.118 ] on October 02, 2006 at 19:27:52:

....take it from me, an 1/8" is a s'keenth too thick.

I got these nifty rectangular 3-in-1 IEC, fuse and switch units, drilled holes all the way around the perimeter and looked forward to nibbling the opening clean. unh-unh!

Half an hour with a file. Ouch!

Replies:

• Sourcing for plate - Shane 17:47:34 10/17/06 (2)
  • Re: Yo, Shane - bill epstein 21:42:40 10/21/06 (0)
  • Re: Sourcing for plate - Wayne Parham 18:47:10 10/21/06 (0)
• Re: If your thinking about an aluminum top plate and using a nibbler..... - SteveBrown 12:54:19 10/05/06 (2)
  • Re: Hey Steve, - bill epstein 16:49:53 10/05/06 (1)
    • Re: Hey Steve, - SteveBrown 19:40:18 10/05/06 (0)
• Where'd ya get em' - Shane 17:49:28 10/03/06 (1)
  • Re: Where'd ya get em' - bill epstein 21:00:55 10/03/06 (0)
• Re: If your thinking about an aluminum top plate and using a nibbler..... - cfranz 09:20:08 10/03/06 (4)
  • Re: If your thinking about an aluminum top plate and using a nibbler..... - Wayne Parham 09:47:53 10/03/06 (3)
    • Re: If your thinking about an aluminum top plate and using a nibbler..... - cfranz 10:01:41 10/03/06 (2)
      • Re: If your thinking about an aluminum top plate and using a nibbler..... - Wayne Parham 13:35:12 10/03/06 (1)
        • Re: If your thinking about an aluminum top plate and using a nibbler..... - 2wo 22:50:56 10/03/06 (0)